‘Extra Height’ Cylinder With Base 500ml Can Cooler/Holder — Product Code 002eh
Fits most 500 ml beer cans world wide
5 mm neoprene
Base: (inside diameter) 60 mm, (-/+ 3% variability) ‘checker plate’ raw neoprene (helps the cooler grip to table tops). Fixed in place with a 2 part neoprene adhesive
Wall height: 140 mm, (-/+ 3% variability) covered both sides with jersey (see colour chart links below).
Seams: firstly glued together with 2 part neoprene adhesive, then zigzag stitching full length of the seam, then tacked top and bottom. Also available with black Mauser tape, sewn on with a running stitch (not required for extra strength — only for visual impact).
Blank size (before forming into a cylinder) 210 x 140 mm (-/+ 3 % variability)
Printing Techniques Available
Single colour Screen Print
Minimum print run 50.
38 Neoprene colors available (see colour chart) and these can be mixed within the order, in minimum multiples of 10.
Plenty of room, for a ‘two sided/front and back’ print. I suggest two 90 x 120 mm art blocks, with a 10 mm gap between. 85 to 90 mm is the visible width of a cooler ‘face’ — so no need to rotate the cooler, to read a message/logo, if kept to this size.
Plenty of room, for a ‘two sided/front and back’ print. I suggest two 90 x 120 mm art blocks, with a 10 mm gap between. 85 to 90 mm is the visible width of a cooler ‘face’ — so no need to rotate the cooler, to read a message/logo, if kept to this size.
Pricing is affected (slightly) by artwork area, and amount of colors printed, so please attach preliminary art to the quote page, or describe in the comments box. Art areas available are 100 x 90 mm, 190 x 45 mm, 145 x 65 mm, 190 x 55 mm, 190 x 70 mm, 100 x 140 mm, 190 x 90 mm.
You are not limited to picking your Neoprene colour from the colour chart. The background colour (which becomes the cooler colour) is printed at the same time as your unlimited colour art, over the top of white neoprene blanks (inside colour black). Once printed, none of the white is left showing.
We are unable to mix the background colors, within an order — each would be a new print run (minimum 24).
Art size maximum 190 x 120 mm (if supplying artwork, your background colour needs to be 220 x 150 mm, which fully covers the 210 x 140 mm blanks, with some ‘bleed off’).
Plenty of room, for a ‘two sided/front and back’ print. I suggest two 90 x 120 mm art blocks, with a 10 mm gap between. 85 to 90 mm is the visible width of a cooler ‘face’ — so no need to rotate the cooler to read a message or logo, if kept to this size.
